Is that the same for my f134 with draft tube?
I have this one. It’s solid and I’m happy with it.
Hmm.. installed their intermediate shaft, bearings and washers about a year and a half ago. Late this spring my intermediate shaft bearings fell...
He says it’s the advanced adapters one
I was going to use my t90, but after the cost of that converstion it is about the same.. would be a little less work I think to do the 420
Doing a 4.3 swap in my 55 CJ5. Would this be something to consider to throw behind it? It has the 4.3 bellhousing with a sm420/d18.
Need a little help with my t90 transmission. 1-R shifts fine. 2nd has a little resistance every so often, 3rd shifts fine 75% of the time.
Mine has it. A little disconcerting. But it’s never not stopped me
I used the old hard lines, but where they convert to soft, I used
Centric Parts 150.66055 Brake Hose
got mine from rock auto.. seems to work fine.
Sorry, not close to NC.. but I have done two t90s now. I have very little mechanical experience and found it to be pretty hard to mess up. Just...
It’s all fairly new.
Haha. I felt like a monkey with a wrench in its hands banging around this thing for the last week.
I saw nothing at all :/
Well I’ll be a monkey’s uncle.
I took the yf completely apart. Stripped and cleaned everything.
Sure enough it’s running right now. 20 inHg...
Normal for it sitting for a day or two. I checked the float level and it was correct
I took the top off and checked the rod. Looked right. I think I’m going to remove the carb and clean it and see if that does anything.
Warm night. But it’s been sitting now a few days and still doing it
yeah it's tight.
Hey Rick, I've been emailing you about this for the last couple days. The carb came from you in October of 2016.
Yeah. I was getting maybe 15-16 at a high idle
Separate names with a comma.