4000-4500 for me in the sand dunes when I had mine.
Yes, I had it balanced.
Find a Scout 300 with the Texas pattern.
The old style seal set-up was the three piece like you have.
Felt, seal, and gasket.
Later it became the one piece seal.
Lots of us still like the...
Put the front bumper at the frame horn up against something solid.
Push in the clutch and bump the starter.
Works every time.
5358092 is T18 from 1977/1978 CJ series.
Some home brew fabbing with that set-up.
3196808 is the AMC part number FYI.
Dusted it off.
Going to Colorado in one month.
Guess I better get started on it.
Install a female needle type grease zerk on the tie rod end.
Just need a needle adapter for your grease gun.
That should give you some additional...
Me no understand either. Never seen anything like this.
Here it is[IMG]
A 4.0 is a 4.0. I think at this stage in it's life emissions wouldn't be a problem.
Don't think they would screw with you too much.
Is the brake line input on your current front cylinders angled or not ?
This will be the only difference you will find.
The front cylinders for...
"Contact seller" Email is blocked by Perterson.
Guess you would have to call them.
Doesn't matter, I'm not interested.
Seems the puzzle has been...
Wanted to buy in classifieds might work.
I asked them for a photo of the VIN plate.
I think it's expert fabrication by person unknown.
1965 Jeep CJ | eBay
The Jeep/Buick part number for that bolt is: 1356635
You can't go wrong with 1-1/8" diameter for the fronts and 15/16" for the rear.
For the front pay attention to whether the outlet needs to angled...
Separate names with a comma.