On my 11"/ 25 upgrade I installed them with the ports towards the back because that's how the 9" were. I don't think it really matters any.
Got a pic? Just because your jeep is titled as a '69 doesn't mean it has a '69 axle under it.
p.s.- why are you pulling the axles?
http://tantel.ca/Images/The%20Sludge%20Pile/Section%20_A_Documentation/Jeep%20rpm_speed_calc.ods (openoffice file)
I've had Tonk to 70....
I'd agree that 6v is fine, going to 8 is just patching over a cable or corroded connection issue.
OK jacked up the back wheels srted up in 3rd floored the throttle & whacked the brakes- stalled out a few times buet then broke loose. bad news...
It's on this weekends to-do list :)
Possible, I'm planning it hit it on the weekend with some pb blaster or equivalent.
All the way. I will mention that although nothing really changed between disassembly & putting the motor back I did find I had to shorten up the...
I've been slowly putting Tonk back together , slowed down radically by some family illness. I finally went to move him yesterday & found that the...
One of these may be the same thing-
Willys Jeep CJ2A, 3A, 3B and M38 Sparetire and Corner Reinforcement
Jeep Wheelhouse Angle Support - CJ5...
That's gonna look Cool. :cool:
Ummm, if they can't see your brakes how do they see your turn signals?
They used to sell kits back'n'da'day for cars, had diodes & a wire to each light.
It will be a standard sized agricultural equipment spline & but will be defined in inches rather than metric.
The cam is different for sure, maybe the distributor & oil pump?
No not really, if the channel is clean & hasn't been doinked the top seam should slide in without too much trouble.
Carpets are nice but don't leave it out in the rain with the top down otherwise all those holes in your floor will be back :(
I think i see an excuse to buy a 3D printer :D
I believe those were used with a lower height wheel house that was intended to make more room for rear troop seats. I think South African models...
The difference is i believe the angles the lines connect to them. I used the AM General postal jeep pieces that have 90 degree connections so...
Separate names with a comma.