There was a discussion not too long ago about this. P/s Brackets
Not on survivors, just rusty junks I have taken apart. I can post pictures if you want.
I have seen black paint on the drums and transmission and transfer case before.
Been there, done that with the brush hog on the back of a jeep. It is a lot of work to steer! I found the jeeps work best with stationary...
Just one observation, why does a 66 with the v6 have a 70/71 clutch cable? Something is not adding up here.
I never touched my voltage regulator. All the battery cables are new and the starter was rebuilt. But the brighter lights and faster crank are...
Spend the money on an 8 volt battery. I put one in my farm jeep and what a difference that made when cranking it.
Thats good. A pin hole can make for a really bad day.
Did you check to make sure the floats still float? They look pretty corroded.
Yes the first year was shortest, but now Novak has a short rear output for the 300.
It doesn't seem much bigger than a dana 20.
In the future, I want to swap the T14 out of Snowshoe for a 4 speed. I saved a T18 out of a Ford truck just for this, but reading into putting it...
Put a WTB ad in the classifieds. Dana 25/27s are a dime a dozen. I'm sure someone will cut one off for you.
I put the transmission in today. Its finally starting to come together! Hopefully it will run soon!
I used the 1970 transfer case mount...
You can make one in an hour for under $20.
I have gotten clutches to break free by chaining (use a long one!) it to something solid and going as fast as I can in 1st (might want to use low...
Separate names with a comma.