Not sure on brand, yes it was new 4 years ago. I couldn't see the tail because it had some material packed around the coil, filling up the...
The Saga Continues: The jeep started acting like it was running out of gas ***AGAIN***, so dug back into the ignition system and fuel system....
I used these guys in 2013. Very happy with the product.
Waldron's Exhaust, car exhaust, truck exhaust, exhaust pipes, mufflers
Here is a link regarding the shifter forks.
t86 t90 gear swap
@oldtime is here also, so will likely comment.
I would start research with Novak.
Novak Conversions :: Transmission Parts
Seems like there are some mods that have to made to the shifter forks...
Fixed all the photos. Now I am upset with at PhotoBucket all over again.
Rear Seat Brackets
Here ya go.
Here are a couple of pics of a Koenig top with ambulance doors.
The set of brackets I have match the tracing you received from John1967CJ5. The seat I have was purported to be a '67 seat. The brackets are...
Check out this thread for ideas on how to hook one up.
Hand Throttle Options
The 2G on a dauntless didn't have a hand throttle. As indicated above there is a manual choke. Here is a pic.
Have seen a pic of a...
Welcome to EJC5. From your Avatar looks like your front end sheet metal is painted Indian Ceramic with an off white inset. My CJ6 is a '67.
So... are your wiper motors 2 speed or 1 speed? PM me if you are interested in the 2 speed switch.
If you have single speed wipers, check out this link.
Wiper motor question?
I think this might be the switch.
NOS COLE HERSEE 2 SPEED WIPER...
Would this work? I think this is a two speed switch, I purchased but ended up needing a single speed switch. I won't be back at my parts and...
Did you get your question answered about the thickness of the eccentric? I have one in my spare parts that measures 0.775 inches. I may have a...
I purchased a kit from Northern Auto parts, was happy with it. I have to say a total rebuild was not a cheap way to go, but I had problems in all...
Found this diagram on the Vintage Ford Forum. Using a Vacuum gauge to fine tune the timing and carb's on my Dauntless got her running very well....
I couldn't get the reproduction brake pedal to work on my 225 V6, don't remember why.
Had two: one from Walcks and one from Kaiser-Willys, both...
Separate names with a comma.