yep, 90* off.
agree with all three
he did say one has a few imperfections
Looks to me like an early 60’s GM column and a Grant adapter. I have a similar tilt column in my Jeep.
or fishing lures
That hard top is a necessity in Pa., not so much in the islands.
I would think if water could get in it should drain out.
how about dropping a Corvair on it
Seems like a lot of work to adjust something to a set point that is dynamic. If I was attempting this, I would get a small adjustable...
I would think a good shot of grease would take care of 1/32” of play.
Including the dogs collar.
Weatherhead fitting. I have a set of sockets that fit all sizes.
Novak has one also.
I believe the head bolts should be re-torqued after the engine has been through a heat cycle.
I run the -4AN from the engine to a bulkhead fitting on the firewall. Inside is the plastic line covered with small vacuum hose, supported well...
Celebrate all the small victories!
IMHO, I’ve never seen a garage that is too big.
I see said the blind man. It does work in reverse but must pass through the neutral or unlocked position. I would think just that little bit of...
It says in the brochure that it works in forward and reverse. If there is power applied, why would it unlock just changing direction? I don’t...
In addition to measuring, fill with the recommended amount and run for a few minutes. Check and mark the full level on the stick.
Separate names with a comma.