Delo 15W-40 for me only because I buy it on sale at Costco. I also use it as gear oil in my KTM.....works great!
Wow this is great! My Jeeptoberfest 2004 shirt is getting a bit worn after 14 years!
It still has most of the gloss although not as much as the photo. I took that photo before the liner was dry.
2 coats of black Monstaliner. It dries smooth so it doesn't hold dirt. Been over a year and it still looks like new.
Yep. If you do go this route, be sure to get a lang lay cable for maximum abrasion resistance.
I work with a lot of wire ropes and rigging in my...
I found that mine was also crooked when changing the oil pump gasket. I was able to use a small seal pick to get it lined back up.
Axle is back in the Jeep and I fired it up last night. The weather was crappy so the initial gear break in drive will have to wait another week...
The cover is on and its back under the Jeep so only time will tell.:driving:
Posi, to me your pattern looks deep as well but it could be the...
The last patterns were at .020 pinion depth and .005 backlash. The drive looked good but I thought it was slightly shallow on the coast side. I...
Both the ARB and Yukon Zip Locker use different carrier bearings because of the seal housing. The shims do in fact go on the outside with these...
Shims go on the outside of the carrier bearings, which is both good and bad. It makes it really difficult to get the shims in on the ring gear...
Here is my SM465 cover. I did fab a new crossmember in order to keep things tucked up nice and high.[IMG]
Whipped up this housing spreader as well.
Here is today's progress. I'm still debating on the pattern and need opinions.
Backlash at .008
Pinion depth shim at .025"
Here is the tank that is on my 71 V6 CJ5
Well I managed to get the housing cleaned, painted, and prepped along with all of the small parts. I started to mount the ring gear to the Yukon...
Separate names with a comma.