It was "rescued" from a scrapyard.
That's facet-nating! :clap:
More info on these motors here:
Good enough reason. (y) I was afraid you were pulling off some super-neat trick and I was missing it. :sleep:
Why the "pie slice" in the middle? Just curious.
I remember a bridge like that across the Mulberry River in NW Arkansas when I was a kid...the diagonal braces would start whipping when we drove...
Old Van Gogh was ahead of his time. :rofl:
I think the easiest way to upgrade the steering in an early Jeep is to get everything from steering box to steering wheel from an intermediate...
.004"-.008" comes to my mind...could be wrong. Try to keep the clearance to low side during setup. Put a THIN coat of sealer between shims to...
Going with a Saginaw box (already mounted). Steering shaft can be seen in the pic.
11" brakes and MC from an intermediate bolted up (without modification) to a V6 MC mount on a 3A frame. Connected last 2 lines and bled. There's...
Last night, actually. I either plumbed the MC to bench bleed...or I developed a new kind of still.[ATTACH]
Good info here:
Not for a Spicer type axle.
Spicer joints use a snap ring; Bendix joints don't. Does yours have Bendix joints? They came in Dana 25s but will fit D27s as well.
I can see the picture. No spacer, it relies on the snap ring.
I did some math and determined that the values listed on the chart I posted a link to above are for a T90A transmission with gear ratios of 2.79,...
Separate names with a comma.