New 4- 1” spacers I purchased off eBay for $55
Alcan spring conversion
Used a 80s CJ shock mount with 1 3/4" round tube extension and stud.
Stock position on the rear using quarter elliptic...
54 from the first page of this thread back in 09
54 from last summer (not the same 54)
Looking for an empty spot on a trailer to haul a CJ from Reno to Colorado Springs. Anytime from today to April 10th
Street legal Roxer rentals in Moab $245 a day.
Gold Label ALI Certification
I have a 10,000 Bendpak and I’m completely happy with it. Well built, great warranty, and customer service.
Those clear plastic filters are typically 10-20 micron, I would be concerned the pump would be working harder then it should pulling fuel from the...
No, for manual steering only.
My first post was to clarify that the FSJ pitman arm will not work with your setup. I would also not recommend reaming a CJ arm (not enough meat...
The stock FSM pitman arm is not flat, the one you have labeled as FSJ looks to be a CJ arm.
The part # Justin posted I'm going to assume he is running CJ steering, if so the drag link end taper is too small for a FSJ arm. I believe the...
Another vote for body color. Sprayed my 3B last summer, easier, and looks better IMO.
Or pull the top cover and count the maindrive gear, the 4.02 had a 23 tooth and 6.32 has a 17 tooth.
I owned a late 76 T18 (J6M) with 6.32 gearing.
Had the 7 shims between the skid and frame.
76 is a crossover year with the later T18's being wide ratio.
A friend with a 304 went with the sniper 4 bbl, dumped too much fuel and returned it for the 2bbl. Working as it should now.
Personally I chose GM...
That looks to be the correct placement of the spring.
It was BobS, sorry for the confusion.
Separate names with a comma.