Mine were 30 spline, more on the story here > Replacement Flanged Axle Shaft
Sorry for straying off your topic,
I got mine from here.
DANA 44 - DIFFERENTIAL CARRIER BEARINGS & RACES - KOYO | eBay
I believe that it is best to use two sets from the same manufacture and modify one set.
The specifications for the bearings can be the same but...
Cool, you seems to score great gear quite often (y)
Here is a picture of my 74 D44 rear flanged showing the axle shaft and related components pulled out of the tube. There is also a seal in...
Flanged axle, right?
The shims would be under the bearing cone on the case, the seals at the outer end of the axle tubes.
Edited to add...
Try this wiring chart.
That wire may be the horn wire
PCV valve / hose to base of carb on right side and vacuum hose from air cleaner on left side.
Right & left referenced as sitting in the driver's...
Here is another version that shows some more of the staring and charging circuits.
It would seem that if the purple wires are doubled up on a single post then the neutral safety switch may be bypassed.
It could have be rigged to...
Is this is any help?
The Jeep pictured & labeled Commando is really a Jeepster/Commando a.k.a. J/C C101.
The actual Commando is nicknamed the "Bullnose"...
I use "Beaming Pix" for a picture hosting site. The price is very fair, the system work flawlessly and the owner/administrator is a pretty cool...
The boiling point of fresh water is raised approximently 3 °F for each pound of pressure applied to it.
Therefore with the boiling point of fresh...
Looks like you got it positioned pretty good, that being said... if you already have the hoses you intend to use then fit them up to the gear and...
It is a win anytime you can venture out with it and return operating under its own power.
You've come very far for starting with a pile of parts....
One way to check the shaft bushings is to warm up the engine and then while at idle spray carb cleaner directly on the shaft / bushing area...if...
If they are in the 4:10 + or - range I would go for them, $500 for the pair in good condition is very fair.
The upgraded AMC 20 should hold up...
I believe that they are factory, both my CJ3B and my C101 have them.
Here they can be seen on the C101 factory drawing, item # 4 and #26
Separate names with a comma.