Showing my age but I remember when you could get your gasket material from the corner phone booth.
My notes indicate the Timken National 473229 applies to both input & output. This is a double lipped seal. Spec'd for 1.5625" shaft. I can't...
Does this help? [IMG] [IMG]
33 x 12.5 on mine. They rearranged some sheet metal at the back of the rear fenders before i had custom springs made. I've given up some turning...
Similar to what I did. I took these pictures when I rebuilt/reinforced the rear frame ends. The new end pieces are what you see here and the stock...
27-3/4" from front of frame horn to front of motor bracket. [IMG]
Correct, it is 1/8" NPT. I used a rather long nipple and tee. Top fitting is for the mechanical gauge. The electrical is a pressure switch...
OzFin is right, some lifter noise is preferred. "Its better to hear them, then smell them".
When I built mine I had a sheet metal shop make the simple bends on the edges. Then you wouldn't have to stitch weld and worry about warping it.
3b a runnin, what jet size did you change to? I use 51's and carry 49's for higher altitude. Tim mentioned books. two good ones are by Mike Urich...
I'll profess that I'm not an expert here. I would think that since you are now reading vacuum from within one of the runners it is affected by the...
Like Norcal 69 said. They all crack in those same locations over time.
Yes, those are good lessons. I've been flat towing for years. I'll drop the shaft for any trip over 100 miles. Got it down to just a few minutes....
Hood hinges with the pins missing?
The distributor experts will answer your question, but it appears to me that your mechanical advance is severely worn. I think I see wear on the...
I've never named my jeep. Maybe I should call her Eileen.
Custom spring packs solved my jeep lean. Knowing that I have a lot of non-stock added weight both front and rear I've found that the standard...
In post #10 I see you have a windage tray. Is that stock? Mine does not have one. 18 years now and I'm still finding out what PO's have removed.
There is a big difference between the big 2 level guns and the pencil types. Having to hold it there is wrong. Rule of thumb is 2-3 seconds for...
As Terry mentions above, the left head sits farther back than the right side head. So if you are using the heads as a visual reference then yes,...
Separate names with a comma.