I believe Walcks has this welt. I have also seen it on ebay.
FWIW. I bought these and they had various thickness shims
DANA 18 & 20 TRANSFERCASE OUTPUT SHIM SET FOR JEEP & SCOUT 1941-79 # A-6753 | eBay
I have the 6 volt petronix version on my 56 cj6 f134 with the stock generator. I have had no issues. Also installed their coil.
Can't say it...
Just for reference these are some Goodyear Workhorse mud and snows that I picked up years ago from Nebraska tire, bias ply 700-15. They have...
Question for the electrical folks:
App: 56 cj6 6 volt with generator
At high idle, reading 6.14 at battery.
High idle: Armature to ground 7.0...
I am 10061.
So if I verify I am ten spline. Who can make me ten spline axles to fit Herm's kit? (Yes I am lazy, or tired)
56 Cj6 stock 5:38 44 rear f head
Will I have to pull the axle to get a spline count, or can I be confident it is a 19? Or the...
I have two, 64 with f head and a 56 with f head, #61 off the assembly line if I decoded it correctly.
My F134 Application. I had the same issue. Eventually had to remove the exhaust manifold so I could work on it. What I thought was clean, once...
My neighbor is trying to get his trailer up and running. He needs a lunette for a m416 trailer. Any suggestions??? Thanks in advance!
[ATTACH] [ATTACH] 56 cj 6 volt, with generator and Walcks harness. A little dark but hope it helps. [ATTACH]
I had the same issue with a T90c rebuild.
I consulted "metalshaper". I belive he told me to flatten or grind off the little tabs. IIRC
Yes, its still there. Not many sellers when its hot. Drove by the other day and there were some hard core folks sticking it out. Thanks for all...
[ATTACH] Nothing fancy here. 1956 f head, still 6 volt,
BDS 2.5 springs. New brakes, exhaust and drive it. Damn near rust free.
Jeep Willys MB GPW PCV Valve CJ2A CJ3A CJ5 M38 M38A1 G503 G740 G758 Crankcase | eBay
See pic #5
Hope this helps. Photo from 56 cj6
[ATTACH] Here's an old one, still working
I had one like yours. Had to take break the nut into pieces. Then had to heat the yoke up and tap it till it broke loose from the pinion.
This is a great review!! I bought a couple a while back and really like them
Separate names with a comma.