Nobody else has replied so far. How much do you want for them? Thanks!
Here is the final product for one of the yokes. The other one ended up looking very much like this one as well. Happy with the results!
I would like the T90 rebuild kit. How much shipped to 33055? Also, I need the T90 cluster gear if you have it. Thanks!
I actually chucked them on the lathe and started turning the yokes down until the groove was gone. My point was: "if I mess them up, they were not...
Sorry, did not mean to do so. Just got carried away. I already posted a new wtb.:oops:
I am looking for the following gears:
Front output gear: 18-8-24, 809291 29 tooth
Front sliding gear: 18-8-22, 809290 33 tooth
Mine are in rough...
Is that a kit with different thicknesses? It does not specify it. And that is my main issue.
My TC only has 2 shims. I would like to have more handy before starting the process.
Thanks! One might think that is almost required when you have to make such accurate adjustments that several thicknesses are available. That sucks!
Where can I find a Dana 18 shim set with different thicknesses? All the sets I've found are all the same shims. I would get that as you fine-tune...
Since the fork is unusable in its current condition and I have nothing to lose, I decide to go ahead and run some TIG beads on the scored side and...
Does anyone know if there is a difference between the shift fork for the front axle with part numbers 18-66-7 and 18-66-8? I need to replace mine...
Thanks! Anyways, it is cheaper than two sleeves (I have a decent lathe) and I will try it before buying new parts. BTW, you have a super clean lathe!
Can I ask you a question? How much did you remove, or did you use some scotch bright? I plan to use a double lip seal but I don't know if removing...
Does anyone know the dimensions or the dash number of the o-rings for the 1 1/4" intermediate shaft on the D18 transfer case? Thanks!
Thanks, Donny! I still need to buy the cluster gear for the T90 in order to have all the parts to rebuild my transmission. I don't want to bother...
Thanks! I wasn't sure sandblasting was a good idea but, what do I know?
Separate names with a comma.