Glen is right about flux cored and welding outside.
The best I have used is "dual shield" Flux cored and gas. Weld anywhere, beautiful welds....
I have a Lincoln 220v MIG. I have used the 110 and think the portability is a good thing. Plug it in anywhere.
Go to your local community...
It is as Petel says in extreme cases. Bottom of the carb. It can also be seen in lesser cases by looking down the throat of the carburetor. You...
I got the last pair, I think. Very nice. I will post a picture tomorrow.
I have that top on mine, the doors are in the back of the shop. Too ugly for the jeep.
F134, 4.27 gears, 29" tires. Overdrive. Maybe 12MPG average. The problem is not the mileage. It's the 10 gallon fuel tank.
As with anything you are coating, the preparation is everything. I have had powder coating and paint both fail from poor preparation. I think...
Thirty five bucks!
So will you make me one for say $25? Using the Black Encapsulating Epoxy?
I got a couple of old but good ones from Walcks.
where did you find the pots? I got some used ones from Walcks.
Mine all work. If you use a brake bleeder vacuum tool on each pot, the actuate and hold vacuum. It's getting vacuum thru the control I have...
I have trouble getting the vacuum (signal) thru the control. The vac pots work ok but maybe I have a leak in the controller. Push button actuate ok.
Looks like very nice work.
Original stuff as much as possible!
[ATTACH] SEM Trim Black. #39143 (I think). From automotive paint store. Nice satin finish, good hiding, tough and once dried, resistant to...
Steele Rubber has all those extrusions and locking strips.
Also why I do business with them. They are the best I have dealt with for new stuff. Midwest Willys for used parts
I just called the above supplier and his tabs are from Walcks and are .0735 thick. Nice fellow.
I had not seen those. They look just like the Walcks tabs. I will call and find out the thickness.
Separate names with a comma.