I will second tomtom, Hobby-Machinists.com.
Greate place to learn about your lathe. Check out Mrpete222 on YouTube.
You said you have it...
I also have an EVO 380, I like the way it cuts! The hot chips will stick to your arms, but no heat transfer to the part. For a back stop, I set up...
"You can do it"
Separate the T-90 from the transfer case.
Make sure the cluster gear and reverse idler gear retaing plate is not in the way....
You sir are a FabMaster!!
Really nice work!!
Evapo-Rust works very well, no material removeal...
I have a 27 PL on my work bench. I am happy to open it up and take pictures to show you what mine looks like.
But will not be back to my...
The race number is LM5013111
The bearing number is LM501348
These are both Bower part numbers
I agree, run it.
The axle is supported by clutches and cup inside the case.
Should not affect anything.
This unit came out of a Scout 80, Dana 27.
The threads are right hand on this case.
The gear ratio is 4.27, from the doner housing. I am going...
And everyone else.
Thank you for the numbers.
This is my second one to do. They can be persicity to get things aligned.
Pictures are always fun[ATTACH]
I am rebuilding a Dana 27 Power-Loc and need the torque for the bolts that hold the case together.
I have been looking for a service manual, but...
Just read your thread. I would like to thank you for bringing back old memories of my first jeep and the lessons I learned by fixing it up...
The T-176 shift tower will work.
Some grinding on the case to allow room for the shift forks is required.
If the trany is the T&C top loader....
I voted for 6 volt. For authentic looks and keeping the flatty more original.
12 volts would be the easy route.
One question is your note about...
Separate names with a comma.