if i remember correct when I ripped mine down,it connects from fuel pump up along frame rail , until you come to cowl section run s up along were...
I chose the 465 for one reason It powers up those 90 deg hills with ease and it didnt require a longer shaft
why not just wire it to the fuse block
looking to swap out stock steering column , steering shaft , steering box , and pit-man ect
trying to find a complete set up is near impossible...
Re: HF pressure pot sand blasting unit - what sand or abrasive to use and where to ge
play sand works as long as it is kept dry
on the 3b 2 coats color 2 coats clear = 2 quarts that yielded 1 gal after reducers / hardeners ect and still had enough left over for touch ups
heres some info on E brake from the 3b page
My eng was doing same thing till I went with different motor mounts , the new mounts helped bring eng over further left and also helped with...
wet sanding will help get rid of orange peal and some of the other crap use a squeegee to make sure you get a uniform finish from sanding
try gravity bleeding I had that happen to me a while back just keep a eye on fluid level in master
locus is the only additive I use
I had a car with a bad slip in transmission added locus runs like new
ford f-150 rims will fit
you should be able to find some at a junk yard they are a very common size
Think this is what he is looking for
how many you need
Did you see the ratchet in the picture its a dollar store special
it has no chance of busting loose that nut , it would just blow apart into tiny...
I'd say take it to a local shop have it impacted off
looking at that socket wrench next to the hammer your looking to bust some knuckles when the...
assuming its like the ones under my 3b the flat one for under transmission and donut under transfercase were sold separate
This should fit under there
Separate names with a comma.