Hard to tell. If it was professionally done, you couldn't tell.
Drive shaft shops only need, (wheels on the ground.) center of u joint to center of u joint. If you give them give them this info and your drive...
My 33X12.5X15 on 8" wide wheels still took a few bits out of the rims. (I expected that.)
I had an issue with putting the front shocks on the rear. I could feel the shorter shock bottoming out.
I also had one come loose. Haven't had a...
I was thinking that I might of highjacked you post. Sorry about that. I see you are coping my fix. Glad to see that may of helped. Good job by the...
You guys can do this. it's not hard.
Welded the cracks in the supports.
Applied weld though primer.
Fit tested the cap.
Welded the cap. (My...
Looks similar to how I mounted my M8274.
The cap is made, not sure when I'll get around to install it. Still need to clean the paint off the floor supports.
Just couldn't under stand the need for a rotisserie. I just laid the body on the sides, top or back. That's all I did when I did my frame off.
My seat belts came from a 1995 Chevy S-10.
Side base mount.
Retractor with custom mount welded the base of the roll bar.
One down fall. They tend to lock you against the seat. Once there it won't let you go. The only way to get released is to unlatch the belt.
Four sizes available. I got the 5.5".
How about a Hat Channel Cap. I bent some 18 gauge steel with my new bender. It may not look pretty when I'm done. There's a few weld in the...
Guess I didn't read to well. I was talking about the trust washer on the output shaft.
I looked at mine the other day. It has cracked again. Thinking of a new way to reinforce it.
I found the last one fit good. The previous one didn't even go over the shaft. I used my old one.
If you do weld the floor. Take everything out of the under seat tool box.
I had the same area problems. I welded a patch over the top. As for the wood in the cannels. After replacing my hat channels with new. There is no...
Amazon. I cut off the pulley swivel ring and installed a bolt.
Separate names with a comma.