Keep workin hard.
Both Land-Rover and Volvo developed these trailers and as far as I know Vovo produced quit a few....
If you are in arizona contact BMI Off-road we are steeped in working on the classic cjs.
Thanks. If I were to go to a salvage yard what years would be good candidates?
Is there an open knuckle front axle that would be a good swap for my 1960 CJ5?
I want to improve my steering starting with the axle.
thats a good idea thanks.
I want to move my turn signal switch to the dash so when I'm wheeling I dont hit my hand on the turn signal lever again. Has any one done this....
Do you have to cut the sroud? what about the p.t.o. propeller shaft?
Are you selling it? What are you asking for it?
Do the flanges separate from the axles shafts? Are the grease zurks at each end of the axle tubes?
well the body is off at the moment.
This is on our '60. It has 2" rancho springs (not my favorite) and degree wedges. Is that a 30 deg. angle? I didn't check but I should have....
I would just have them Finnish the job if they have it apart. If you have them put it back together and take it somewhere else they are going to...
I just searched for 1960 jeep universal vehicles paint chips and I got what I needed to know.
thanks guys thats just what I needed too.
I will buy the springs from you.
Thank you for the help muchachos!:flag:
I need some for my floor pan. Where the heck do you get those things?
Separate names with a comma.