This may or may not of be some interest
my latest build is a 54 CJ3B, 79 CJ7 axles and a 70 Jeepster 225 V6, T14 dana 20
since the original 70...
What size is the outlet on a 225 fuel pump
1/4 pipe doesn't screw in
looks like a flare inside
Got it working better, tookit apart, ball at the end of shifter was about 1/3 gone, welded it and ground back to a ball,
the left rail was worn...
checked out the permatex web site, then picked up some #2 for my oil pan, then looked in my gasket seal drawer, and yep, had some, its just been...
Been a while since I used any gasket sealer
what is best performing or favorite ?
On a 225 V6 where do I find the emission plugs for the head
there are 3 on each side, 4 are plugged I need 2, it is a strange thread
Looking for info on rebuilding my Dana 20 shifter, it is the single handle U type pattern. It shifts ok, but it is kind of loose and just flops...
waht si Fsm?
What manual has a good breakdown of the 225 / trans / xfer case?
Is a Buick 198 V6 distributor the same as a 225 V6 ?
Separate names with a comma.