Like Charlotte NC.
I have been here 4 years and I'm still amazed.
Congratulations nice job. When I do a clutch I always hand fit the bushing to the input shaft before installing it in the crank. Like you I have...
Oh I see a another project in my future.
My 67 would not be fun without it.
Yes, there is no synchro in first gear.
That's what works for me too.
I used this kit in a 69 Bronco. It turned out nice.
Or what was sitting around.
Wow Flashback! I remember going their to pick up stuff for a small shop that I worked at in Burbank Ca. It was called California Four Wheel And...
I bet the springs are the old Rancho Freedom Rider. My dad won a set and put them on his 73. I remember they would break all of the time. The leaf...
I ceramic coated my headers and exhaust. It helped a bunch. Is it perfect? No, but it is way better.
I'm not an Omix guy but these are what I'm using. I will say they are very good but not perfect. Some of the threads on the Hardware and grease...
I don't care for Omix-Ada parts at all. However I am running their HD greasable shackles and bushings. I like them allot.
I would do a test hole on a piece of scrap first.
This is what I run.
I took the pan to a radiator shop (Because they where next door to where I worked.) and removed the part that was going to be in the way of the...
I put a TH400 in my Scout with a Dana 20. I did have to modify the transmission pan for the front drive shaft.
I hear you. We just didn't want to take a chance. He had a ton of money into the Bronco.
I restored a 69 Bronco with a complete new system and used dot 5 to protect the paint. Four years later and everything is just fine.
Separate names with a comma.