The pulling is adjustment most likely. All too many people rip em right apart and never use them. Make it safe and use it. Mods and upgrades will...
it ran and drove home,stopped ok? steering is decent? fix the obvious safety issues and get some seats that fit a little better. and drive it.
X2 on fluid film. Other than the smell not a bad thing to say about w
Metal clips like a brake line. Mounts inside the rail Look like this....
prusa i 3 its a kit will print about 8x8x9 I have never tried it before and I love a challenge. plus it will make the rc hobby a little cheaper...
I have a buddy that makes crazy shafts for paper mills and the like he owes me a huge favor or two ....
Waiting on my 3d printer kit as we speak.
Now all I need is the drawing for the shaft.
Should be 11 inch on a 73 measure across the backing plate where the drum would ride should give some idea
If you are comfortable doing a timing chain and oil pump you aren’t that far from pulling it apart and putting new internals if needed. I...
"the journey of a lifetime starts with the first step" its somebody's quote but rings true.
fwiw my brackets are under that lip on the tank.
just got one myself....cant believe I waited this long. now im looking for things to cut up.
if you cut from the top brace it well the flip can cause misalignment . I usually work from the bottom. get the floor fitted and attached then do...
Or just be sure to run it for a little with no load before calling it a night
I’ve had the one wire type and didn’t have good luck....on more than one occasion. Your results may vary.
A one wire has this weakness I go three wire with the sense wire tied in to the dash wiring where the voltage matters
I smoothed the oil ports in the pump and matched the timing cover to the block no other oil mods fifty plus cold idle and thirty five idle hot.
If it sees salty water fluid film before exposure and it may not rust so fast.
Use rectorseal at my job so yeah I’ve heard it
Separate names with a comma.