1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Alt? Delco 12si vs 10 si?

Discussion in 'Jeepster Commando and Commando Tech' started by DaveFL, Feb 13, 2009.

  1. Feb 13, 2009
    DaveFL

    DaveFL Member

    Joined:
    Jun 19, 2008
    Messages:
    59
    Okay When I rebuilt my engine I used a Delco Remi 10si to replace the orginal unit that was fried.

    Im looking at going to an electric fan, and getting rid of the fixed fan since I can't stuff a clutched fan into the engine bay with the HEI, just cant get the room.

    Anyone know if there is a big differnce in size with the 12si vs the 10si? I know the 10si was a direct swap offering 63amps, the 12si offers 105 amps. Im worried about amp draw with electronics and an electric fan and I don't know if 63 Amps will cut it.
     
  2. Feb 13, 2009
    Vanguard

    Vanguard Take Off! Staff Member

    Vista, CA USA
    Joined:
    Aug 30, 2006
    Messages:
    2,256
    Last edited: Feb 13, 2009
  3. Oct 26, 2009
    DavidWymore

    DavidWymore Member

    El Centro, CA
    Joined:
    Sep 29, 2009
    Messages:
    259
    I've heard of this issue with HEI/fan clearance before but for some it doesn't seem to be an issue or they just don't mention it. I'd like to go HEI but not electric fan.

    Also, I'm looking at going 12SI too, cuz I think the reg in my 10 is dead and I have some 12s around.
     
  4. Oct 26, 2009
    LarryD

    LarryD Member

    Gallup NM/ 4 Corners
    Joined:
    Jul 7, 2006
    Messages:
    637
    I have a 10SI with a 105 amp stator I found on Ebay. I think the Mad electrical link above addresses the issue of overheating with the higher amp options on the 10SI but I am not running high draw options like fan or fuel pump, I think in your situation I would go with the 12SI.
     
  5. Oct 31, 2009
    Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    cordele, Ga.
    Joined:
    Mar 29, 2007
    Messages:
    5,916
    You need to add up your total load that could possibly be running continuously. That will determine what size alt you will need. The amp output of an alternator is not continuous duty. In other words a 63 amp alt cannot put out 63 amps for very long. Few minutes at most and then it fries..
     
  6. Dec 28, 2009
    nhjeep

    nhjeep NH Jeep

    NH
    Joined:
    Mar 6, 2008
    Messages:
    113
    I searched the previous threads viewed the websites on the threads and I have just rewired my 69 cj5 w/v6. The only thing extra on the jeep is a AM/FM radio, a DUI distributor, and up graded the head lights to the a good Silvana sealed halagon. Planning on going wih a 10si or 12si. I removed the motorola 37amp alternator and regulator. Should I go with 10si or 12si? Will these fit the bracket without any modifications? Which clock position is the alternator at?
    Thanks in advance,
    Mike
     
  7. Dec 28, 2009
    Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    cordele, Ga.
    Joined:
    Mar 29, 2007
    Messages:
    5,916
    If you want to stay with Motorola, they do make that same size in a 60 amp. The red plate on the back will have two diodes in it versus one for the 37. If you decide to go Delco, just mount it on the existing bracket but you my have to make spacer and washer changes to line up belt. The clocking on the Delco is easier at 12 o'clock.
     
  8. Dec 28, 2009
    nhjeep

    nhjeep NH Jeep

    NH
    Joined:
    Mar 6, 2008
    Messages:
    113
    OK, Thanks
     
  9. Dec 29, 2009
    duffer

    duffer Rodent Power

    Bozeman, MT
    Joined:
    Sep 17, 2009
    Messages:
    4,457
    Alternator loads are discussed above but I did not see any mention of an electric winch. A winch will cause the alternator to run at full capacity while in use and for a period of time afterward as it recharges the battery. All winches I have worked with will draw even more current than a 160 amp alternator will produce, the extra draw supplied by the battery. If you have or are considering an electric winch-go the 12SI route.
     
  10. Dec 29, 2009
    w3srl

    w3srl All-around swell dude Staff Member

    Port Orange, FL
    Joined:
    Nov 6, 2002
    Messages:
    4,275
    A second battery with an isolator is also a good idea with a winch, if you have the room.
     
  11. Jan 1, 2010
    aallison

    aallison 74 cj6, 76 cj5. Has anyone seen my screwdriver?

    Green Cove...
    Joined:
    Nov 24, 2006
    Messages:
    1,929
    Can also use a CS series alt. Very similar to the SI series. My CS I will run is a 144 amp unit. Another choice if you need to run a winch. And a lot less expensive and you can get parts/replacment at any autoparts store.
     
New Posts