1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

pinion seal removal...

Discussion in 'Flat Fender Tech' started by Andy4802, Oct 14, 2008.

  1. Oct 14, 2008
    Andy4802

    Andy4802 Canadian Jeep junkie

    Hudson, Qc, Canada
    Joined:
    Jul 30, 2006
    Messages:
    410
    trying to change out my rear pinion seal... so far i have the driveshaft off and the big nut off and i cant get the dust shield off over the seal... FSM says to use a puller to get the seal out but how do you get the dust shield out? Can i do either without a puller?
     
    Andy4802, Oct 14, 2008
    #1
  2. Oct 14, 2008
    Homebrew2

    Homebrew2 Member

    Dunlap, CA
    Joined:
    Aug 17, 2007
    Messages:
    511
    The dust shield should be part of the yoke ... they come off together. You'll probably have to yank it with something, puller, wire and slide hammer, drilled flat stock bolted to yoke and tap ends with hammer.
     
    Homebrew2, Oct 14, 2008
    #2
  3. Oct 14, 2008
    Andy4802

    Andy4802 Canadian Jeep junkie

    Hudson, Qc, Canada
    Joined:
    Jul 30, 2006
    Messages:
    410
    got it out! yeah... what i thought was a dust shield was just part of the seal... it got mangled on the way out but i got it out with a screwdriver and a small pry bar. new one was a bit different looking but it fit perfectly :). thanks
     
    Andy4802, Oct 14, 2008
    #3
New Posts