front reciever = removable coupler

Following Mike's idea
http://www.boyink.com/jeep_comments/39_0_2_0_M2/

I replaced the stock lunette setup on my M101Cdn w/ a new fab'd front receiver. I was going to have to remove 1/4" off the stock drawbars, but didn't want to ruin any possible future restoration project, so I made new drawbars too.

This is only a CAD rendering of it, but I will post up some pix after I get it all bolted up tonight.



Thanks,
wally

 

Here it is bolted up. Will be adding a regular jack instead of the pivot landing leg

 

Here's mine, which uses the standard Bantam T3-C casting. It is basically a "shoe" which fits over the square tube at the front of the casting and bolts to the "A" frame. It can be removed and the trailer restored to "100% original" with the original Fulton hitch.





Yes, it is inspired by Mike's idea.

Robert Bills
Orange County CA
'46 Bantam T3-C #9466