1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Trans And X-fer Case Covers- To Seal Or Not To Seal

Discussion in 'Intermediate CJ-5/6/7/8' started by Dale Park, Nov 27, 2021.

  1. Nov 27, 2021
    Dale Park

    Dale Park Member

    Utah
    Joined:
    Feb 15, 2021
    Messages:
    114
    I had to take my trans, x-fer case covers off to update my Dana 20 Xfer case shifter to remove the slack. I was wondering what you guys use if any as far as a sealant between tub and cover. When I did the full rebuild, I used butyl tape and it works good, but is a nightmare to clean off for replacing covers. I would not be replacing it except that it stuck real good on tub side and cover side so when I lifted it off it tears etc.
     
    Dale Park, Nov 27, 2021
    #1
  2. Nov 28, 2021
    Desert Runner

    Desert Runner Member 2024 Sponsor 2022 Sponsor

    Hickory, Pa
    Joined:
    Sep 11, 2005
    Messages:
    819
    I use plumbers putty
     
    Desert Runner, Nov 28, 2021
    #2
  3. Nov 28, 2021
    PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Hills of NH
    Joined:
    Aug 3, 2003
    Messages:
    9,806
    PeteL, Nov 28, 2021
    #3
  4. Nov 29, 2021
    Chilly

    Chilly Active Member

    Joined:
    Mar 12, 2007
    Messages:
    1,486
    Cord caulk here too. When I took apart my 73 it was under hood hinges, between cowl and fenders, between fenders and grill, and all those tranny hump cover pieces.
     
    Chilly, Nov 29, 2021
    #4
New Posts