1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

225/t18 Quick Clutch Question

Discussion in 'Early CJ5 and CJ6 Tech' started by givemethewillys, Nov 8, 2019.

  1. Nov 8, 2019
    givemethewillys

    givemethewillys Been here since sparky ran it. 2022 Sponsor

    New Kent, VA
    Joined:
    Jun 21, 2005
    Messages:
    1,998
    Hey guys, I'm swapping in a 225 and t18/dana 18 into my cj5. The t18 is a jeep case with a ford input shaft. I just had the thought that because of the ford input shaft, the standard dauntless clutch might not fit. Is this an issue?

    Which clutch do I need for a jeep 225 to T18? I'll be using the standard flywheel.

    Thanks guys! My 225 is in the machine shop and almost done. My dana 18 and t18 are freshly rebuilt. Everything is getting close to going back in the jeep, I'm so excited!
     
  2. Nov 8, 2019
    Norcal69

    Norcal69 Out of the box thinker 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Northern California
    Joined:
    Sep 6, 2014
    Messages:
    3,547
    Might want to check out this thread.....

    Help Me Get My T18 Clutch Released!
     
  3. Nov 8, 2019
    Twin2

    Twin2 not him 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Virginia Beach, VA
    Joined:
    Apr 28, 2011
    Messages:
    5,407
    not sure if ford input is 1 1/16 10 spline like jeep
    jeep transmission I used got a ford clutch disc
     
  4. Nov 8, 2019
    givemethewillys

    givemethewillys Been here since sparky ran it. 2022 Sponsor

    New Kent, VA
    Joined:
    Jun 21, 2005
    Messages:
    1,998
    Thanks for the link norcal69!

    Twin2, I'll have to go measure....
     
  5. Nov 8, 2019
    nickmil

    nickmil In mothballs.

    Happy Valley, OR
    Joined:
    Sep 23, 2002
    Messages:
    12,529
    Pretty sure Ford is 1 1/16” and GM is 1 1/8”. Jeep depends on what it came out of. There are at least 12 different T-18 input shafts...
    common to use a Ford disc with GM Pressure plate and flywheel. Don’t forget the custom pilot bushing to match the larger pilot of the Ford input shaft. Should be readily available from Summit, Jeg’s, Partsmike, etc.
     
New Posts