1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

To Pertronix, Or Not Pertronix...that Is The Question

Discussion in 'Early CJ5 and CJ6 Tech' started by TonyM, Oct 25, 2019.

  1. Oct 25, 2019
    TonyM

    TonyM Member 2023 Sponsor 2022 Sponsor

    Middle Tennessee
    Joined:
    Jul 30, 2017
    Messages:
    170
    1956 CJ5, F134, 6v. So...I completely rewire the entire jeep with a Walks harness and after a bit of tinkering with the tail lights, everything works as it should. Runs properly, with lights, horn, gauges, everything is groovy. BUT, I don't get to drive the jeep often and have to "clean" the points and replace the condenser more often than I'd like because of lack use (and poor quality parts). Like today when I go out to start her up and it just cranks and won't start. Check the points and they look bad because I haven't really taken the jeep out for a while.

    Like many on here, I'm tired of this. As much as it goes counter to my "keep it stock" ethos... I've purchased a Pertronix electronic ignition unit.

    Once the unit gets here, it looks like the install will be very easy. My question is, from a performance/usage standpoint - is there anything that I should be aware of down the road? Anyone have long term experience with Pertronix ignitions?

    I've read most, if not all, of the related posts on the site, but wanted to get additional advice/stories, if any.

    I've been a points/condenser guy for the 20+ years I've had old jeeps, but I'm tired of the hassle...
     
  2. Oct 25, 2019
    foor18eddie

    foor18eddie New Member

    Southern california
    Joined:
    Oct 28, 2018
    Messages:
    3
    I can’t really say it helps performance but it sure does make start ups pretty easy no matter how long it sits.
     
  3. Oct 26, 2019
    mickeykelley

    mickeykelley Well-Known Member

    Republic of Texas
    Joined:
    Oct 10, 2015
    Messages:
    1,900
    I fought the points, etc thing for almost a year after I got Willie. Gave up and went Pertronix and not looked back. Fires right up without even needing any choke. Just a partial squirt with the gas peddle and starts right up. Now, as a backup, I carry a small box with the points, plate, screws, etc., should I have a total failure while out and about, I can put myself back to points. When I researched it, I found most people had years of service with no issues. So far for me it's been 3 years without firing issue. Other issues but not distributor.
     
  4. Oct 26, 2019
    colojeepguy

    colojeepguy Colorado Springs

    At the foot of...
    Joined:
    Apr 4, 2010
    Messages:
    7,110
    I put my Pertronix unit in somewhere around 20 years ago...never a problem.
     
    65CJ5 SRD likes this.
  5. Oct 26, 2019
    65CJ5 SRD

    65CJ5 SRD Member

    NM
    Joined:
    Aug 12, 2019
    Messages:
    103
    One of the best things I did to the Jeep. I fussed with the points for awhile, but I had a lot of point slap with the high revs the F134 runs at. Only Pertronics issue I ever had was the tape holding the magnets in the little "donut" gave way. The company sent me a new part at no charge and I haven't had trouble since.I did double wrap the donut with some good electrical tape just as a precaution.
     
  6. Oct 26, 2019
    TonyM

    TonyM Member 2023 Sponsor 2022 Sponsor

    Middle Tennessee
    Joined:
    Jul 30, 2017
    Messages:
    170
    Thanks guys this is encouraging!

    Forgot to ask - i’ve read a couple things on the web, not on this site, that might indicate that the Pertronix unit has some issues when operating with a generator rather than an alternator. Any of you still use a generator?

    I believe the generator issues were related to a Buick odd fire six cylinder engine which is not what I’m dealing with but wanted to ask nonetheless.
     
  7. Oct 26, 2019
    FinoCJ

    FinoCJ 1970 CJ5 Staff Member

    Bozeman, MT
    Joined:
    Jul 18, 2013
    Messages:
    5,593
    Did the v6 ever come with a generator? I thought it was always a 35amp Motorola alternator. At one point there was discussion about installing the ring upside down in the OF v6, but think that was resolved years ago. Has worked great in my v6 for 5 years...not experience with it in a 4cylinder.
     
  8. Oct 26, 2019
    58 willys

    58 willys Sponsor

    Millsboro, Delaware
    Joined:
    Jul 2, 2010
    Messages:
    944
    I put the Pertronics on my father in laws '62 Impala 327 with generator never had any problems with it that was over 20 years ago
     
  9. Oct 26, 2019
    Howard Eisenhauer

    Howard Eisenhauer Administrator Staff Member

    Tantallon, Nova...
    Joined:
    Nov 22, 2003
    Messages:
    8,102
    Issue # 1- Pertronix will not work on 6 volts, requires 8 volts minimum. :(
     
  10. Oct 26, 2019
    TonyM

    TonyM Member 2023 Sponsor 2022 Sponsor

    Middle Tennessee
    Joined:
    Jul 30, 2017
    Messages:
    170
    Are you saying that the 6v Pertronix unit won’t work with 6v or that I’ll have to get an 8v battery and adjust the voltage regulator to use their 6v unit?
     
  11. Oct 26, 2019
    Howard Eisenhauer

    Howard Eisenhauer Administrator Staff Member

    Tantallon, Nova...
    Joined:
    Nov 22, 2003
    Messages:
    8,102
    I'm not aware of a six volt unit for the jeep, got a part number?
     
  12. Oct 26, 2019
    TonyM

    TonyM Member 2023 Sponsor 2022 Sponsor

    Middle Tennessee
    Joined:
    Jul 30, 2017
    Messages:
    170
    Pertronix 1541N6. Their website, and the guy I spoke with there, said it’s designed for the 6v system and compatible with my distributor (IAD 4041) and the F 134 4 cylinder jeep engine.
     
  13. Oct 26, 2019
    maurywhurt

    maurywhurt Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Western North...
    Joined:
    Dec 12, 2009
    Messages:
    873
    I think Pertronix used to produce only 12V kits, but just learned they now make point replacement modules for the 6 volt jeeps as well. The only reason I know is that earlier this week, I installed a 12V Pertronix kit in my '67 V6 CJ-5. Being impressed with it, I looked to see if there's a Pertronix kit available for my 6V '42 GPW, and there is.

    I believe the Prestolite distributors use model 1541N6, and that model 2541N6 fits the Autolite distributors.

    Unless I'm mistaken, if installing a Pertronix module, you should also install the correct Pertronix coil as well. I'm not sure which of their coils would be the best model for the 6 volt jeeps.
     
    Last edited: Oct 26, 2019
  14. Oct 26, 2019
    Howard Eisenhauer

    Howard Eisenhauer Administrator Staff Member

    Tantallon, Nova...
    Joined:
    Nov 22, 2003
    Messages:
    8,102
    Well by golly! A six volt Pertronix!!

    I stand corrected Sir, carry on. :)
     
  15. Oct 26, 2019
    Glenn

    Glenn Kinda grumpy old man Staff Member

    Apopka, Fl
    Joined:
    Sep 21, 2002
    Messages:
    12,367
    I wonder if the reference to a generator resulted from 2 problems. 1st would be a weak battery, 2nd would be if #1 was combined with too much idling time = no charge.
     
  16. Oct 26, 2019
    TonyM

    TonyM Member 2023 Sponsor 2022 Sponsor

    Middle Tennessee
    Joined:
    Jul 30, 2017
    Messages:
    170
    The guy I spoke with at Pertronix said my existing coil (from NAPA) should work just fine. We’ll see, I guess.
     
  17. Oct 26, 2019
    fyrmn

    fyrmn Member 2023 Sponsor 2022 Sponsor

    High Desert AZ
    Joined:
    Apr 29, 2006
    Messages:
    198
    I have the 6 volt petronix version on my 56 cj6 f134 with the stock generator. I have had no issues. Also installed their coil.
    Can't say it helped performance, but starting is definitely quicker and it idles smoother.
     
    Last edited: Oct 26, 2019
  18. Oct 26, 2019
    Jw60

    Jw60 Sitting up n buckled down. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Sedalia MO.
    Joined:
    Apr 8, 2008
    Messages:
    4,716
    My father inlaws just put a 6v pertronix on his farmall super c. He went to show me and the battery was to low to crank the starter. it still fired right up using the hand crank. Pretty sure it has the stock generator.
     
    Glenn likes this.
  19. Oct 26, 2019
    maurywhurt

    maurywhurt Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Western North...
    Joined:
    Dec 12, 2009
    Messages:
    873
    On my '67 V6 CJ, I've noticed easier starting with the Pertronix, better idle, and it seems to have a bit better throttle response as well.
     
    Last edited: Nov 15, 2019
    Beach66Bum likes this.
  20. Oct 26, 2019
    Glenn

    Glenn Kinda grumpy old man Staff Member

    Apopka, Fl
    Joined:
    Sep 21, 2002
    Messages:
    12,367
    Cool!
     
New Posts