1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

CV Q

Discussion in 'Early CJ5 and CJ6 Tech' started by fivos, May 30, 2004.

  1. May 30, 2004
    fivos

    fivos Member

    Athens, Greece
    Joined:
    Jun 27, 2003
    Messages:
    109
    If your driveshaft has alot of angle you put a cv joint on the yoke of the tcase and you can rotate the axle to the proper angle. But what is going on with the axle lubrication is it good or bad. Would it be better to put a second cv to the axle or this is not an option.
     
  2. May 30, 2004
    Glenn

    Glenn Kinda grumpy old man Staff Member

    Apopka, Fl
    Joined:
    Sep 21, 2002
    Messages:
    12,367
    Lubricating the pinion bearings properly is the biggest concern. Tilting the axle lowers the plug on the axle cover, so unless you remedy the situation the oil capacity is less. At what point it would cause a problem I don't know.
     
  3. May 30, 2004
    fivos

    fivos Member

    Athens, Greece
    Joined:
    Jun 27, 2003
    Messages:
    109
    you are right i never thought about the fill plug and that the oil capacity would be less. Then can i use a cv for the axle yoke
     
New Posts