How are the locating dowels on the spring pads? I have seen these allow the axles to move. Easy to miss.
As I recall there was a rubber "flap" attached to the pedal itself. When the pedal is up it's "sealed" (dust seal at best) other holes, like for...
AC Bill, is your CJ a V6 or the 4? I don't know if the 4 cyl. had the same setup.
My '69 CJ5 has had 3 owners including me. The second owner only maintained it and drove it for about a year, when he got a newer Jeep (bigger,...
I have used both Bill Hirsch and Eastwood sealers. If you get them cure befor use the are both very good.
When the clutch and the above parts were assembled and did, sort of work, the clutch had a normal pedal, but very abrupt engagement. The only...
My pictures are on my phone. Between my phone and my PC I can't get them to where I want them to go. I have tried a couple of times. The last TO...
Abrupt clutch engagement may finally be gone. '69 CJ5, Dauntless V6, T98 4 speed. After over 3 months in the shop I drove the Jeep home today. All...
As to the question of is the tranny a T98. Cast on the side of the case, drivers side as mounted, is a large T98, and some other things, Not on...
Ok. I sent the Jeep over for a new flywheel. Carolina Clutch, where I bought the LUK clutch set suggested the flywheel after I told them that it...
sorry my picture down loads seem to be over 10mb. my pictures are on my phone. I tried to send them via my phone but all that went in was dark.
Driver side of transmission showing T98 cast in
The LUK clutch set I bought was the gold set. I didn't see it before my repair guy put it in. The set I put in had a diaphgram PP and the big head...
Yes, it is a T98. At that time The problem was replacing a broken TO bearing guide. I found that the front support from a T10 Muncie was the same...
Separate names with a comma.