A two groove crank pulley and a two groove water pump pulley please Thanks Dennis
Expensive but it has a high yoke, might work with a Dana 20? Hi-9 in a Ford 9” housing Would be very very short driveshaft though. Dennis
I used a dimple die on my boxed sections approximately every 12-14 inches. Stitch welded the additions, from the frame horns to the rear including...
PM sent
These are what I bought for my M38A1 http://www.canvasco.com/ Post war jeeps tab
Thanks for the offer, got one yesterday in the mail from another member. Sorry should have made a note in the wtb Dennis
No problem, thanks for looking
I have a couple of possible things for trade: 3 groove pulley Or a set of the AA aluminum windshield hold down clamps Or?
Tymbom did this if there were any hot rod places near me I would probably put louvers in the same place [ATTACH]
The housing is plastic, connectors and body are sealed against moisture. Think I bought them from a trailer supplier like:...
I am using these https://petersonlightsandharnesses.com/product/led-stop-turn-tail-lamp-157/ [ATTACH]
Separate names with a comma.