If I’m reading your drawing correctly, I read it to say starting at 0 degrees, TDC of Cyl # 1 that it is firing #2 plug, Im thinking make existing...
That sounds right! When you tried tims change did you move the wires 1 position and rotate the body to line up the rotor to the new number 1...
Here is a thought, if you are using the wrong post on the distributor for #1 (incorrect primary timing). then the next time it fire on 150 instead...
Ernie, if you have future plans to add efi installing an hei would be benefitial. Efi requires a digital tach signal that you cant get with...
Which bank is running even or odd?
Ernie, you said you have the points breaking. Have you pulled a plug and visually seen the spark at the plug?
I had the exact same problem with my 198 when I got it. Fuel port on one side of carb was plugged with dirt. If you have compression you are...
When I put the Gm efi on my 198, I used an HEI oddfire distributor modified with a 7 pin ignition module,(85 corvette), never had an signal issues...
That offy is a rare find especially since it wont fit the other buick oddfire 6s
Tim you’re right, the injector is different, I have sourced injectors from junk yards cheap and not had problems, jw60, I checked inventory at...
The efi system is the identical on the 350 as it is on the 4.3, just a chip change.What I ran into with other vehicles was that the harness...
I ran 1987/88 gm efi On my 1962 198. Ran great. The donor vehicle you want is an untouched 87 or 88 chevrolet or gmc van full. Harvest the...
I did make that power steering bracket, don’t know about the flywheel, the engine was a 1962, don’t know if there were Any differences. Were you...
Hey Jonbrew, gave all my 198 parts to Zack
Zack, whts happening on the 198?
Separate names with a comma.
