Are these headers made to fit INSIDE the fenders or outside?
Do you know if this Jeep has the Warn full floater conversions? I have a Warn FF rear in my CJ2A and the Hubs do take a bit of rocking and...
Sand blast followed by powder coating.
are you putting a Dauntless in a LR?
You could simply mount two taillights on a piece of plywood and fit two rods or pipes to fit into the rear bow pockets. The make a simple wiring...
Taking yur Jeep apart is slippery slope. Stay with the plan.
masscj2a -- what swing away tire/can carrier did you use. Did you have to modify it?
I lined the underside of my '47 with Raptor Liner - and the underside of the fenders. Also used it in place of mats on the front floors. I saw...
I believe that Summit Racing sells a remote oil filter kit for Buick V6 engines. About $50 - $60. There are several manufacturers.
I used stainless pan head, slotted machine screws with anti-seize. Had a hell of a time getting the original bolts out, and did not want to go...
The in-tank fuel pickup that goes up and curves over is pretty standard for a Jeep. I had my 80 series Landcruiser set with two tanks. IMO this...
This is a very reasonable approach. Almost all tire services, dealer shops, etc. will inflate your tires to max recommended pressure. I am running...
Your would likely have a problem fitting 235/85/R16 radials to stock 16 X 4.5" wheels - I think the tires would be too wide for the rims. Here...
Mark - I am running load range E. My plan is to run with far less than the standard 80 PSI. I do this on my F350 when I am not towing the boat or...
I am running a set of Cooper STT Pro... 215/85/R16 on 16 X 6 rims. nice tires, but about 31" tall.
Separate names with a comma.
