Before id condem that head id have it maged if im thinking correctly the Buick v6 engines need sealant on the head bolts if there not sealed right...
I will guarantee the panels at Army jeep parts is 100% accurate i work for George from time to time (i build his axles) and i have been there...
love this, great build, keeping it simple . Just one complaint the alum wheels got to go. Was wondering what trans your running ? and did they...
I would have killed for the orange tub out hear I rust land nj
i hope your kidding about cutting this up to a make a 6 .
Just a little more advice that ive seen many rookies and even professionals make be very very carefully with brake clean it will puddle and ignite...
Thats funny cause i ran the high port heads for years on a an odd fire engine and just bolted them on. Yes you are right about the oiling but when...
buick v6 intakes dont go by odd or even fire they go by tall or low port heads all 225s were low port the high port heads will fit on a 225 find...
just remove the bolt and cut it flush with the top of the spring. those clamps are one there to help keep the springs in line and stop the...
you should have bought both of them just so you could have that top that is cool you will regret that some day
If you want to find some really good info on swapping gm fuel injection go to binder planet they have great info listed on there site.I am shore...
FYI you can run a u-joint at an angle like that it just has to stay in the proper plane
As for the R12 to 134 when we changed (hear in the USA) the company that I was working for sent me to school for AC The instructors told us...
what size and make up of tire (radial or bias) are you using? if you are using a big bias tire check the tire pressure bias tires can have major...
It is very doable . just keep in mind that everything has to be in line with the carrier if your starting with a bear tubes and housing you will...
Separate names with a comma.