I'm about to put my 225 back in my 2a and am trying to decide what carb to use. The motor is stock other than a DUI distributor and headers. I...
Yup, I have a tom woods 1310 yoke for the 20. I will most likely go with the WT 30/20. What I should do, is buy big boy axles for my 86 and...
I considered that also but was trying to go low buck. Won't a cv shaft help enough with angle issues? Can I still use the factory 47 crossmember...
I will not be running the Dana18, I already pulled it and will use Dana 20. I am still in the air about which tranny, maybe a t176. It's a shame...
I have been looking at different routes to take for an axle swap. Is the WT Dana 30/amc 20 the easiest swap? I found a set of scout 44s for $250...
I think I will go with them. The mounts that are in it now are from a CJ5 I believe and are kinda crappy looking. thanks
Looks like what's happening is the gear in the starter is not pulling/disengaging fully and getting chewed up by the flywheel. You are looking at...
I am pulling my 225 out to replace the existing motor mounts. The PO had done the swap and the welds and placement are ugly. Has anyone...
Yeah, that was kinda what I thought. I didn't think there was that much difference in the overall width though, dang. My main concern was...
I have an opportunity to get a complete Scout II Dana 44 axle with the auto hubs for $265, or less without the hubs. Will that axle be an ok...
I wish I could say that was the case. The PO did a hack job with the SOA, left the old SUA perches on and welded shock mounts to them. I have...
Separate names with a comma.