1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by shaun

  1. shaun
    Post

    I Might Quit

    I hear you I’m in the same boat. I might sell mine as well. I also have a lot of parts that can upgrade on the 66 CJ as well.
    Post by: shaun, Sep 11, 2022 in forum: Quitters' Club
  2. shaun
    Post

    Overheating

    I filled it abou 1” above the coils. I looked in it today and it has plenty of coolant in it. Has room for expansion. I need to look for a CJ5...
    Post by: shaun, Aug 22, 2022 in forum: Early CJ5 and CJ6 Tech
  3. shaun
    Post

    Overheating

    Yes I talked to my buddy here and I think we are going o do that as well as I may look at the water pump as well, seems like it takes awhile to...
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  4. shaun
    Post

    Overheating

    I could replace the grille with a mid 70s which would be not as deep and put that radiator that goes with that grille, then I can put the fan as a...
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  5. shaun
    Post

    Overheating

    Oil pressure is about 6-10 at cold start it’s low but bumps up to 6 and when high idle kicks off it’s about 8-10
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  6. shaun
    Post

    Overheating

    I tested the t-stat before install and it’s operates, the fluid was filled to top
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  7. shaun
    Post

    Overheating

    It was pushing fluid out overflow tube.
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  8. shaun
    Post

    Overheating

    I was thinking my water pump could be bad, I have a spare in garage I may have to look at that.
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  9. shaun
    Post

    Overheating

    It’s a large 17” fan that just made fits in my grille. I believe it’s a high output fan. Ill have to check again
    Post by: shaun, Aug 20, 2022 in forum: Early CJ5 and CJ6 Tech
  10. shaun
    Post

    Overheating

    Engine has great vacuum and when I had it 5 yrs ago when I was rebuilding the jeep I found I needed to replace the intake manifold, couldn’t find...
    Post by: shaun, Aug 19, 2022 in forum: Early CJ5 and CJ6 Tech
  11. shaun
    Post

    Overheating

    High speed like 30+
    Post by: shaun, Aug 19, 2022 in forum: Early CJ5 and CJ6 Tech
  12. shaun
    Post

    Overheating

    Yes
    Post by: shaun, Aug 19, 2022 in forum: Early CJ5 and CJ6 Tech
  13. shaun
    Thread

    Overheating

    So I have a 225 with 4bbl carb and elect. Push fan because I wanted to go with electric and it doesn’t fit with upgraded radiator. But my...
    Thread by: shaun, Aug 19, 2022, 34 replies, in forum: Early CJ5 and CJ6 Tech
  14. shaun
    Post

    Spline Upgrade

    Well originally I believe the jeep was a 62 m38a1 with C channel frame. So if it’s a 10 spline can I upgrade to 19 with all of Herms FF kit and...
    Post by: shaun, Aug 16, 2022 in forum: Builds and Fabricators Forum
New Posts