I use a big bolt that is just a little bigger then the pilot bushing hole. Don't remember the size but it starts fairly easily and one bottoms out...
[ATTACH] Mine measures just under 47". I've never had it installed and figured I'd have to shorten it since I changed to a t19 and added an...
Went to a farm auction and must have flinched which resulted in me bringing a 2 bottom John Deere plow home.
I think the shaft could be flame sprayed. I don't know if they could do the inside if a gear. Flame Spray Metal Coating Services near Denver, CO |...
If it has 20 splines its from a dana 45 out of 1958 or 1959 chevy half ton. Have 2 of those in my garage. The dana 45 is a hybrid with carrier...
I know a truck one will not fit in a cj. Its clocked such that it runs into the cross member going forward.
T19 worked out well in mine. I did it the cheap way by using the output shaft from a scout T19 and the adapter from a Jeep T18 (with some...
I figured you'd know. (y)
Not to add more confusion but my distant memories of running Holley's at high altitude also include changing the power valve. Not remembering the...
Do look at it as a problem. You don't need the top on when its in the garage. Most of the times you are looking to drive it on nice days. On the...
I bought one like you are looking at and found it barely better then the trial and error method. If you are not doing many setups save your money,...
Having had had a flanged axle shaft exit my axle housing I'd say not worth the effort. If you're looking for an improvement over tapered go full...
I mounted the transfer case mount on the lower step of the cross member so the tranny could be lower without lowering the cross member.[IMG] Had...
I was just trying to debunk the made in USA good, everything else bad, mentality. That said I'm running a Zip Locker in the rear and have since...
Thought ARB was made in Australia
Separate names with a comma.