Speechless...
Put an angle finder on the engine. You want to keep your driveline slope at a max of 3 degrees. Your ebrake shouldn't be that low. A mild body...
It's nice but someone got a decimal point in the wrong place. Being sold out of Texas and the bidder keeping things moving is "Texas Presidente"...
It is a simple task to change the lower end of your driveshaft to the 1310 end yoke. Any competent shop should be able to do it. I wouldn't use a...
I think you could pull the spacer and fan, pull the grille back and go electric.
Oof, bet it has nasty rear axle wrap issues.
Wrapped up! Scavanged a furnace and power converter from a junk camper. Reinstalled the water tank, added a 12v pump, have an on demand cowboy...
Cores are like $30-40 if you don't have them. That's a good price if you have them though
Edited my post Joe is correct the caliper bracket for both the factory 6 bolt and GM conversion goes on over the spindle. Brain fog made me go...
The caliper bracket goes on after the spindle. The calipers for the factory setup are notoriously expensive, starting to get harder to source and...
Bluntly that thing is a pos
Agreed first thing that comes to my mind is a lean condition for some reason.
I was completely unprepared for that! Specs would be nice ( asking for a friend..)
Turn the knob fully clockwise to it's stop then pry it off.
Separate names with a comma.