I found the answer. There is a rubber bushing that goes between the hex on the shackle sleeve the goes through the frame and the spring end, and...
Right. Just not sure if I installed them incorrectly, or if have the wrong part installed, or if I just need to take up the space with a spacer or...
Got the pictures up. Wanted to get this suspension figured out so I can move on to some other stuff. Thanks for any advice!
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Hello, I have a conundrum regarding my springs. My Jeep is a CJ5, but the frame was so rotten I had to replace it. I found a pretty solid M38A1...
Ah, I see. Mine is with stiffer. My replacement is without. Thank you.
I purchased a frame for my CJ5 since mine was beyond repair from rust (Connecticut). The new frame is from an M38A1. The rear bumper apparently...
I actually do have 2.5" of lift. I have the BDS suspension.
Well shucks. I replaced the frame with an M38A1 frame. No more bump stop.I think that bracket is going bye bye. Thanks everybody for your input on...
No, it was always spring under. And it's only on the passenger side.
If I try to turn the knuckle to a hard right turn the caliper makes contact with a bracket of sorts welded to the axle tube. Is this bracket...
I am installing disc brakes on my 66 CJ5. Does the position on the caliper look correct?
Separate names with a comma.
