I have a 1970 # 8705F17 62472 DOB Sept 1969
On my jeep the shocks mount on the backside of the axle also. Could you just swap the lower spring plates to the opposite side that would make...
That is a nice looking hardtopR)R) I like how you repaired the 2 holes in the top , I was just going to weld a plug over them. Your jeep is...
What I did on mine when it broke was grind off the weld on the back side of the stud and then ground off the front side took a big punch and...
The stock wheels from the Ford will not work because your lockouts are too big for the center holes in the Ford wheels how ever if they are...
That is one great looking find .If it was mine all I would do is drive it and not touch anything else. :roll: :roll: Ya right
Yes they are . One sure way to check is to measure the hieght of the old tire it should be around 28 or 29 inches.
Is your motor the L head or F head , if its the F head just a heads up if you take the coil off of the motor make sure you drain the radiator...
I just bought a 1966 CJ-6 V-6 3 speed D-18 single stick. It was missing the vin plate so I cleaned off the frame and this is what I found for...
Well I just checked to confirm my gear ratio on the 66 it is 3.73 On my 65 it is 5.38 and on my 64 it is 4.27 so I guess I will be using Droopy...
I am running about half throttle so the revs are keeping me from going faster .I am turning about 3500 rpm;s and showing about 47 mph. I also have...
I just bought another 1966 CJ-6 with a V-6 in it ,and it looks like it has the 3.73 gears. My question is, can I run this gear ratio in my 1965...
I use 20-50 Castrol in the 65 all year round, but I only use the jeep in the winter to plow with [ no heater ] so it doesnt get used to much as a...
Separate names with a comma.
