1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by MNTrailboss

  1. MNTrailboss
    Post

    fiberglass body

    Have an AJs tub on mine with the color impregnated gel coat. It's been on my 74 for about 4 years now with major offroading every year -- note...
    Post by: MNTrailboss, May 14, 2007 in forum: Intermediate CJ-5/6/7/8
  2. MNTrailboss
    Post

    lift for 75 cj

    CV shaft might be a big help, but you don't need to spend big bucks. My rear CV shaft comes from a donor Cherokee front shaft. Total cost was...
    Post by: MNTrailboss, Mar 2, 2006 in forum: Intermediate CJ-5/6/7/8
  3. MNTrailboss
    Post

    T18 to Dana 20

    A JEEP T18 will bolt right up. That's my configuration.
    Post by: MNTrailboss, Feb 17, 2006 in forum: Intermediate CJ-5/6/7/8
  4. MNTrailboss
    Post

    What's a good clutch for my jeep?

    I have the Centerforce 1. Works fine, and clutch pressure is even lower than stock -- saves on my left knee. I offroad all the time and have had...
    Post by: MNTrailboss, Feb 7, 2006 in forum: Intermediate CJ-5/6/7/8
  5. MNTrailboss
    Post

    Hood Fitting

    Thanks guys, Sorry for the late replys. Business took me from wintery Minnesota to sunny Costa Rica, where the CJs and FJ-40s litter the...
    Post by: MNTrailboss, Jan 27, 2006 in forum: Intermediate CJ-5/6/7/8
  6. MNTrailboss
    Thread

    Hood Fitting

    I want to hack up a hood to put in some louvers to cool down the engine bay. I've wrapped the exhaust and installed a new radiator but the 360...
    Thread by: MNTrailboss, Jan 22, 2006, 5 replies, in forum: Intermediate CJ-5/6/7/8
  7. MNTrailboss
    Post

    Spring Perch

    Thanks, I'll give 'em a ring and order a pair.
    Post by: MNTrailboss, Oct 26, 2005 in forum: Intermediate CJ-5/6/7/8
  8. MNTrailboss
    Post

    73 CJ5 304v8 Value?

    Rust, dent, smash, scratch free '73 Jeeps with very solid original tubs go for a bit more here in the salt belt of Minnesota. I bet you would...
    Post by: MNTrailboss, Oct 25, 2005 in forum: Intermediate CJ-5/6/7/8
  9. MNTrailboss
    Thread

    Spring Perch

    I found a rear 44 axle that was changed to spring over for the wider wrangler springs. I want to weld on the original spring mounts under the...
    Thread by: MNTrailboss, Oct 24, 2005, 7 replies, in forum: Intermediate CJ-5/6/7/8
  10. MNTrailboss
    Post

    Edelbrock headers

    Not sure what headers on a 304 is gonna do for ya as I've run the stock manifolds on 360s and 401s and they breath plenty fine with a good 2.5"...
    Post by: MNTrailboss, Jul 18, 2005 in forum: Intermediate CJ-5/6/7/8
  11. MNTrailboss
    Post

    Steering Shafts

    Thanks for the feedback.
    Post by: MNTrailboss, Jun 8, 2005 in forum: Intermediate CJ-5/6/7/8
  12. MNTrailboss
    Thread

    Steering Shafts

    Any difference between steering shafts for a '74 manual, to a power setup? I got the power gearbox out of a 79 CJ. Bob
    Thread by: MNTrailboss, Jun 6, 2005, 4 replies, in forum: Intermediate CJ-5/6/7/8
New Posts