Thank you, thank you, thank you. I will learn to live with it and maybe one day I will install Saginaw steering.
1962 f134 fresh off frame build.
I have 31x10.50x15 tires and a completely rebuilt Ross steering system from the knuckles up.
It is very hard to...
My old pinion seal says ASD 142235. Is this a Willys part number? Came from a 3B D25.
Anyone know a National equivalent ?
The new bearing will be the front pinion bearing. I dinged the original and instead of taking a chance I decided to replace it. Might make my...
Carrier installed with a little dead blow hammer persuasion.
Pinion preload is 10"# as best I can tell with my little torque wrench.
I have a new...
I'll check everything again tomorrow. I'll try to get better photos.
I don't understand the question about how tight the carrier bearings are.
Here are photos of the contact pattern. The ring gear backlash is .003.
What do you think?
The gears were used in a complete axle that I bought. I don't know the history but the teeth on both R&P looked good but there was some slack...
I will install and check contact pattern.
Both gear ratio's are 5.88. The R&P are not a matched set. When I opened the differential
the wear pattern actually looked good. I will try to...
what will happen if I run a front axle with mismatched ring and pinion numbers?
Separate names with a comma.