I did it too on the front and the rear. If I remember right the CV yoke is out of an early bonco
Try JC Whitney. I bought my 2 1/2" superlift kit thru them, I think they had a 4" too. I'm selling me 2 1/2" springs if you decide to stay with...
Kevo, Is that a Ford T-18 or the Jeep T-98? I have the Ford and I noticed that your PTO cover is on the drivers side, mines on the passengers....
M38s had the larger gas cap with the pull our funnel, waterproof 24v electrical system, shovel and ax (as mentioned) blackout lights, headlight...
Where do you guys get your rubber mounts for flattie radiators? I have an M-38 the I mounted the radiator to the grill, now I'm going back to the...
You shouldn't have to lift the body and lower the tcase if you are using the stock tranny/tcase. My dad and I both have M38s, I lowered the...
What heater did you buy? I have thought about putting one in my jeep, but the problem with the M38 is there is a battery where the heater would go.
I got everybodies PM about the springs. If I remember correctly, the rears are 42" eye to eye and the fronts are 36". I will measure them...
I have a set of superlift 2.5" for an M38 in the shed if you are interested. I thought they were very good springs, they flexed well and the ride...
I used to have 1.5" .120 wall tube come off the frame, run under the rocker and go back to the frame. They worked real well for a long time. I...
Are you sure that book says pints? There is a big diference between 3 pints and 3 quarts.
I think the spec on the 18 is 3 quarts. I don't know about the 90. Just keep putting oil in them till they start to overflow the fill plug. If...
Mine is a pusher. I have it mounted to a homemade bracket bolted to a Buick 225. I mounted my motor/trans offset to the drivers side 1.5 inches,...
When I set up mine I had the piston fully compressed, and mounted it so that there would be no pressure on the throw out fork. That way there is...
Separate names with a comma.