After I pressurized with air, I re-bled with fluid, as the air pushed the fluid back to the master cylinder (and out the seal on the top, and all...
I am really struggling with these brakes. I have replaced pretty much every part. I replaced the master cylinder twice after the original and...
I am really struggling to figure out what brakes I have. A previous owner did the 9" to 11" conversion. All the springs for sale seem differant...
I have about a 1979 Buick 231 in my 1960 CJ5. I have already rebuilt the heads, carb, etc.. and replaced all the accessories. I have a wide...
One thing to remember on these calculatoions is that 33" tires are normally about 32". Use the real size of a 33" or 31" or whatever tire, thus...
I am redoing all the brakes on my Jeep, and was able to find the rear wheel cylinders no problem. I cannot seem to find the ones for the front....
I'm trying to replace the front brakes on my Dana 25. The PO upgraded them to 11", I also had a set of Warn locking hubs on there. I have the...
The book for 1980 Buick 231 says .060, but I think this is way too much. I put in Bosch platinums that are pre-gapped, and not intended to be...
I just towed mine from Milwaukee to Lafayette, Indiana. I rented a 1990 GMC 1500 from rent a wrecks, and I rented a car carrier from U-Haul. The...
I bid on it I am the winning bidder on it now. Is the cable all that I need now? Is the emergency brake as straightforward as it looks? Hook...
One of my mid-term projects I want to complete on my Jeep is to get a functioning parking brake. I have the drum mounted on the drive shaft,...
Separate names with a comma.
