Okay guys. In another post, I asked if the rubber ring that's in the harmonic balancer was any good. Truth be told, I went over that son of with...
I read that it’s not an easy part to obtain for my year/engine due to reproductions holes not being aligned. If I didn’t need to replace it then...
CJ5 1974 258 i6 Hello Jeep lovers! I was working on the engine and I was removing paint from it and when I got to the harmonic balancer and I...
Blasted the valve cover with garnet sand and cleaned ready to be painted! After a little repair work on the bolt holes.
What book are you checking?
I’ve read somewhere that using a nut driver tightened by hand is sufficient torque. Is there any validity in that statement?
I’ve cleaned up the valve cover for the 74’ CJ5 AMC 258 l6 and was wondering in this picture I have attached. Does this bolt hole need to be...
The backlights worked as far as I can tell. It has been a couple of years since I last ran the jeep. Currently, I’m working on it doing a frame...
Not sure if this will help, but I have a t18-1b here is a picture of what mine looks like
Thanks you guys!
howdy folks it’s been a while since I’ve been on the site. I have made it to the point of this rebuild where the engine is ready to go on the...
Separate names with a comma.