upper shock posts?
Planning to just drill a hole in my existing spring plate, once I figure out if am going to use the 1” or the 3/4” offset. Don’t know why a 1/4”...
I had a lockright in the front and rear with 33x10.50 and original ross set up and big wheel. Most of the time it was fine. If you were going...
As for the rear spring hangers: I ended up moving re-drilling holes and moving them back 1.5" but now the tire sits alittle too far back in the...
The dana 30 came back from the shop. It got cleaned up, with 5.38s and an e-locker, and beefy ball joints. I ended up not doing chromoly shafts to...
I appreciate the input as always. I already have the cj7 calipers/etc so I am going to keep it stock since no one has said the gm performs...
I got my dana 30 back from the shop to replace my old dana25. It is from a 1980 cj7, and I know it has the 6 bolt caliper bracket and the thicker...
As an update to my sniper stalling issue. After sending in logs to holly tech support, it turns out it was exhaust leaks upstream of my 02 sensor,...
I'll post some pictures this weekend, but I finally measured to see how off the Rocky Road kit put my rear axle. I used my handy laser level and...
Well I finally found a narrow track Dana 30. It’s alittle crusty but it was close and cheap. Next step is to the axle shop. I have dreams of...
Mine came with a dual output pto and a front winch and a rear gear box. I really wanted to keep them, but ended up selling them off to fund other...
I think herm over drive guy sells something like that to use an overdrive plus pto. I have a sm465 and I don't really know where I would route the...
Correct, you can tighten the tension and they are little detents where it clicks as you twist the throttle. Loose and it will pull back with...
Separate names with a comma.