I wondered why LSD are no longer offered in late model trucks (Fords). I supposed it had to do with fuel mileage. Takes HP to turn with friction...
Thanks Oldtimer I found a fella that could make a (name and instruction plate) with a altered shift pattern but the max mph per gear part is a...
Hello Have a 54 cj3b with t-18 reverse over a down. Looking to have a orginal style Willys dash plate with speed (MPH) for each gear and 4 speed...
Hello Might think about some sort of a safety pin to lock toggle u-arms to latch bracket. If tire carrier ever got loose it could be bad. Bill in...
Hello I have replaced several output shaft bushing. What worked for me was. Had to make a driver to install. I think it was a short chunk(3...
Hello again I would advise to read Novaks guide on rebuilding dana 18 TC. If your front yoke has any movement up and down or sideways your...
Hello I have replaced several output shaft bushing. You will need metal lathe, drill press, 11/16 drill bit, 5/8 reamer and bushing driver....
Thanks for comments. Duffer, early block, no side motor mounts. No room for 2 grove pulley on balancer anyway.Now looking at flat belt drive...
Thanks for response. w3srl,there is about 1" between front edge of fan and radiator core. If I use a double pulley on balancer I would have to...
Hello everyone I need advice on mounting a belt driven power steering pump on a 3b with SBC. It has a cradle type front motor mount. There is...
Hi I would try to find a 3b junk hood and cut spot welds out. Will be hard to duplicate the radius. I think a 2A,3A hat channel brace would also...
Hi avmechanic I have enjoyed following your build. I too have a dilemma with regards to front tire coverage. I have not found any aftermarket...
Has anybody ever tried cutting axle shims from key stock on a horizontal band saw?
Separate names with a comma.