I would just buy any old Chevrolet passenger car TH400, and build a replacement transmission for the Jeepster with the adapter and output shaft...
Man, I'm in uncharted water. I'll talk Jason and get his advice on how I should proceed. Look how much easier this would have been If I'd been...
I was wondering if I could use my D20 on another GM trans. I'm a Mopar guy and know a lot of that stuff in my sleep. (kinda why I stuck to it.)...
No. This is getting out of hand. I wanted to be able to switch back to stock motor/trans if The notion took me. I'd be way ahead to just pull the...
OK. I've gotten some bad info and ran with it. Are you saying that the rear of the buick V6 in my JC is the same as a chevy 350? I found this,...
I want to do a TDI conversion on my 67 JC. The pre made adapters are from TDI to Chevy TH400 but Jeep used the BOP TH400 so only the bottom bolt...
I have a 67 Jeepster Commando and it's slated for a VW TDI. I started watching facebook marketplace in my spare time, within 100mi. Not too long...
yup, mine are 10 3/8 inside to inside. wont fit. I wondered if a guy couldn't run a bead of mig weld across the bumps and adjust them out.
Thanks for sending the build link. I like the wheels. I'm pretty sure I can get custom back space on this wheel when ordering. I'll have to sell...
yup. me too. I'll check out your build , thanks
Which ones, what backspace? Any pics? Don't tease me like this. :) I've seen where folks are running 33x10.50s on stock JC wheels. It's one...
It's cold and I'm not going out. So, I'm thinking about my 67 JC project and chasing rabbits. I'd like to keep my OEM hubcaps but would like wider...
Nice find. Hope somebody steps up.
Separate names with a comma.