Here is mine mocked up. I have good clearence against the firewall and room up front for a rad and a pusher fan between the rad and grill. I have...
What's up with your front driveshaft? If it is what I think it is than that is one of the worst inbreed bastard creations I have seen in a while. lol
It was a joke. jeep toss
Looks clean for being so old.
The rear is boxed in, tomorrow I'm gonna knock out the middle. I still have a little welding left but it's almost done. [IMG] Plated the front...
Thanks guys. I bought some pedals out of YJ, will the bolt up to my cowl and firewall? I figured they had to be close since a YJ has the same tub...
You'll have to bolt the transfer case to the rear end and use pivoting mounts for the engine.
Make sure to check that there is no water in that transmission, it can go right around the shifter.
38.5 tall TSL boggers, I don't remember the width though.
I own a 1967 CJ6. I bought the jeep for $1200 and it had a 225/T18/D18/Warn Overdrive. Here is what it looked like when I bought it [IMG] [IMG]...
Are those headers from speedway? I was thinking about a set of their stainless block hugger headers for my CJ6.
If you need a new one I got a set of new ones. This is what you need, the flat one. [IMG]
The frame is sandblasted and primered, along with the rear end, springs, and skid plate. Tomorrow I want to paint the inside of the frame and weld...
I want to keep it together with the whole drivetrain.
Thanks, it's gonna be badass when it's done. :) I got the spacers for the steering box mount machined. When ever ballistic ships me some DOM...
Separate names with a comma.