1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Todd Haire

  1. Todd Haire
    Post

    T-90 Shift Removal

    Thank you. Much appreciated
    Post by: Todd Haire, Sep 17, 2023 in forum: Early CJ5 and CJ6 Tech
  2. Todd Haire
    Post

    T-90 Shift Removal

    The Front Axle “in and out” shifter is against the OD in direct drive. Everything is just on center. Just not a lot of room.
    Post by: Todd Haire, Sep 17, 2023 in forum: Early CJ5 and CJ6 Tech
  3. Todd Haire
    Post

    T-90 Shift Removal

    [ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
    Post by: Todd Haire, Sep 17, 2023 in forum: Early CJ5 and CJ6 Tech
  4. Todd Haire
    Post

    T-90 Shift Removal

    Post by: Todd Haire, Sep 17, 2023 in forum: Early CJ5 and CJ6 Tech
  5. Todd Haire
    Thread

    T-90 Shift Removal

    Hello, I always felt the shifter was a bit tall but after putting in an overdrive my T-90 shifter gets tangled up in second gear. What is...
    Thread by: Todd Haire, Sep 17, 2023, 15 replies, in forum: Early CJ5 and CJ6 Tech
  6. Todd Haire
    Thread

    Jeep Leans

    Hello, Before I dig in what do you think the cause and remedy would be for a 53 Cj that has a driver side lean or sags a bit towards the drivers...
    Thread by: Todd Haire, May 29, 2023, 25 replies, in forum: Flat Fender Tech
  7. Todd Haire
    Post

    Input Gear Removal

    Thank you! This is why I love this site.
    Post by: Todd Haire, Feb 26, 2023 in forum: Early CJ5 and CJ6 Tech
  8. Todd Haire
    Post

    Input Gear Removal

    Thank you, thank you!!
    Post by: Todd Haire, Feb 26, 2023 in forum: Early CJ5 and CJ6 Tech
  9. Todd Haire
    Post

    Input Gear Removal

    Thank you. That’s the answer I was looking for.
    Post by: Todd Haire, Feb 26, 2023 in forum: Early CJ5 and CJ6 Tech
  10. Todd Haire
    Post

    Input Gear Removal

    Thank you. Just wanted to check with the pro’s before I did something wrong. That was on my mind but wanted to double check.
    Post by: Todd Haire, Feb 26, 2023 in forum: Early CJ5 and CJ6 Tech
  11. Todd Haire
    Thread

    Input Gear Removal

    Hello, Working through a OVERDRIVE installation on a Dana 18 T/C. My question is after removing the cover and nut on the input shaft I’m having...
    Thread by: Todd Haire, Feb 26, 2023, 8 replies, in forum: Early CJ5 and CJ6 Tech
  12. Todd Haire
    Thread

    Pto Removal

    Hello, Slowly making progress removing a Koenig twin stick front and rear PTO. I’ve removed the five square head 3/8” pipe plugs and then removed...
    Thread by: Todd Haire, Feb 9, 2023, 1 replies, in forum: Early CJ5 and CJ6 Tech
New Posts