1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

H Tate's Recent Activity

  1. H Tate liked XXIIILIV's post in the thread Vibrations.

    If it doesn’t work as it is now, the double cardan is the next step

    Mar 26, 2024 at 6:16 AM
  2. H Tate liked PeteL's post in the thread Vibrations.

    Just a thought - have you had the shaft out and the splines apart? The two yokes MUST be synchronized.

    Mar 26, 2024 at 6:16 AM
  3. H Tate liked XXIIILIV's post in the thread Vibrations.

    No, they are 8 degree

    Mar 25, 2024 at 5:02 AM
  4. H Tate replied to the thread Vibrations.

    Interesting. Someone must have corrected the use of aluminum after I ordered mine. Were they 3 degrees?

    Mar 24, 2024 at 2:46 PM
  5. H Tate liked PeteL's post in the thread Vibrations.

    Call Tom Woods. They'll tell you exactly. https://4xshaft.com/collections/jeep-cj-products/products/cj-rear-drive-shaft-double-cardan...

    Mar 24, 2024 at 2:45 PM
  6. H Tate replied to the thread Vibrations.

    There are several options but delivered it was $479. X spline, greaseable joints and the 10 spline yoke for the T-case. Just make sure...

    Mar 24, 2024 at 2:45 PM
  7. H Tate replied to the thread Vibrations.

    I will add this, the shims that came with the Rough Country lift are aluminum and should be replaced with steel shims like the ones from...

    Mar 24, 2024 at 7:12 AM
  8. H Tate replied to the thread Vibrations.

    Ha Ha!

    Mar 23, 2024 at 5:26 PM
  9. H Tate liked XXIIILIV's post in the thread Vibrations.

    Damn you!!! Why ya gotta show me cool stuff like this

    Mar 23, 2024 at 5:26 PM
  10. H Tate replied to the thread Vibrations.

    No, all factory except the springs of course and new shackles to replace what ever the previous owner put on for a lift.

    Mar 23, 2024 at 8:30 AM
  11. H Tate attached a file to the thread Vibrations.

    I went with a double cardan shaft and transfer case yoke from Tom Woods. [ATTACH]

    20240323_054805 (Medium).jpg Mar 23, 2024 at 6:54 AM
  12. H Tate liked sterlclan's post in the thread Vibrations.

    all the ujoints good? what kind of angles at each end ? [IMG] image stolen from another post

    Mar 23, 2024 at 6:46 AM
  13. H Tate liked Lockman's post in the thread Deceleration Backfire.

    Ok....I didn't realize you have a new distributor in . There is minimal wear or ' slop ' then . Carry on & Good luck to you. BTW,...

    Mar 22, 2024 at 7:54 PM
  14. H Tate replied to the thread Deceleration Backfire.

    Not recently. When I put the DUI distributor in a year and a half ago I set it for 10 degrees. Ibdid checkbit a few months ago. I will...

    Mar 22, 2024 at 7:00 PM
  15. H Tate replied to the thread Deceleration Backfire.

    No, luckily

    Mar 22, 2024 at 12:32 PM
New Posts